Centreboard banging

For general discussion about the Cape Cutter 19
Post Reply
Julian Porter
CC19 Association Member
Posts: 74
Joined: Fri Jul 12, 2019 1:57 pm

Centreboard banging

Post by Julian Porter »

Is it normal for the centreboard to bang on the casing when sailing in heavy seas?
erbster
CC19 Association Member
Posts: 712
Joined: Fri Apr 06, 2012 7:57 pm
Location: Midlands
Contact:

Re: Centreboard banging

Post by erbster »

Yes, I’m afraid so. We call it the clonking plate.

Usually happens in a swell with light winds. Either put up with it or put it up... :)


Cape Cutter #86 Aurora
travellingaurora.wordpress.com
Charles Erb
CC86 Aurora
travellingaurora.wordpress.com
User avatar
zimp
Non Association Member
Posts: 137
Joined: Tue May 25, 2010 12:59 pm
Location: Netherlands

Re: Centreboard banging

Post by zimp »

I agree with Ebster, put it (partly) up. I always keep some tension on the centreboard wire.
Bert, CC19, #004, s/y Zimp
erbster
CC19 Association Member
Posts: 712
Joined: Fri Apr 06, 2012 7:57 pm
Location: Midlands
Contact:

Re: Centreboard banging

Post by erbster »

Downwind, it obviously does less work, so if it’s clonking, you might as well pull it up (but the boat will roll noticeably more). If you raise it going to windward, you make a lot of leeway (doesn’t usually clonk in that situation though)

A couple of seasons ago, our centre plate was jammed up during a holiday, so I was forced to sail with no centre plate down. I was horrified at how much leeway we made and my wife was horrified at how much we were heeling....


Cape Cutter #86 Aurora
travellingaurora.wordpress.com
Charles Erb
CC86 Aurora
travellingaurora.wordpress.com
Post Reply