by zimp » Thu Mar 01, 2012 11:30 pm
I've been playing with jack-stays last summer.
First I installed two jack-stays from the transom cleats to the sampson post.
Secondly jack-stays from the winches to the sampson post.
It turned out to be not very practical. It all interferes with the fore hatch.
Finally I installed two U-bolts in the font-side of the cockpit, just above the floor. Now I can clip on while in the cockpit or below decks. I can reach the whole cockpit while hooked.
When I have to go on deck I clip on the halyards or the shrouds.
This is not an ideal solution, may I'm going to install some hard-points on the mast or on the tabernacle.