Most viewed - CC19 Members Gallery

Home > User galleries

Most viewed - User galleries

93 viewsPositioning prior to Sikkaflex and bolting together. These plates were made by a stainless steel fabricator in Volos Greece. He took the sketches and had the rudder in his workshop to make sure it all worked out OK. He also drilled the rudder for the new plates. Cost of S/S work in total €120. Pretty good value I think.

93 viewsSelf steering, very easy to adjust by using a flexible (rubber inlay) rope

I fabricated the stainless steel to work with the MSR Dragonfly stove (uses same petrol as outboard)93 views

92 viewsNew fixed block arrangement

92 views29 V 77 Ah battery for the electric outboard engine. The battery provides you with a rough estimation of its charge state via five LEDs on its control panel.

92 viewsMain sail lashing 4 (cordage shackel, length 400 mm)

92 viewsEngine cover and winch mechanism removed

92 viewsLow cost tiller holder and self steering equipment

91 viewsBlack Sheep 001. Modification of the keel to accomodate the Torqeedo electric engine.

91 viewsRemovable aimdships "T"-track mounting cleat

Mounts to the boat using clamps (centerboard case, compaionway, transome, table, all work depending on situation)91 views

90 viewsBoat Tent- Side Access

90 viewsTiller pilot in place. The socket is an interference fit (heavy push fit) into the bracket

90 viewsSpot of lunch, tennis on the radio.

90 viewsTwo berth mode with enhanced storage.
Remaining quarter berths have been extended to increase their width (and comfort).

545 files on 37 page(s)

CC19 Members Gallery

Shared gallery for Capecutter 19 Association Members