73 viewsRemoval of the single thumb screw on the step gives quick access to the front of the engine
73 viewsThe plywood supports that clip over the transom and compensate for its 18 degree slope (keeps the support frame upright)
73 viewsMk1 Dashboard under construction (fitted to stbd cabin wall, now replaced by mk2 with bookshelf).
73 viewsUllswater, raining again
72 viewsAt its mooring. Note position of engine controls
72 viewsGulp! Drilling a 42mm hole in the hull (for log impeller). Stbd side, under cockpit.
72 views1. And the lake went up 50cms!
72 views
72 viewsmast fitting for gooseneck
71 viewsCockpit engine cover moulding
70 viewsStowed for travel
70 viewsDetail of pennant staff (bottom)
70 viewsThe base is the full width of the cockpit and fits at the back of the transom behind the cockpit drain scuttles. I have cut a section out at the bottom to allow for my outboard well plug and cover (see inboard engine installation photos
Most viewed
Home
Login
Return to Forum
Album list
Last uploads
Last comments
Top rated
My Favorites
Search
