Cape Cutter 19 Association Forum

Has anyone tried/uses leaded anchor warp? I've been looking at this stuff -

http://www.seamarknunn.com/acatalog/liros-leaded-rope-anchor-line-with-bag-30m-x-10mm-7523.html#.UoUl9XRFCUk

A bit more expensive than having a chain and rope, but possibly easier to stow. I reckon 10mm would be strong enough for a CC with a CQR anchor (which I already have - it came with the Dabber but was far too big at 15lb for her really. Any opinions?

Steve

Looks a good idea as any extra weight helps set an anchor. I've not seen any opinions of this sort of thing though.

Hi Steve,

I'm using this "ledded" ancor rope if we are doing lake cruising on the Tegernsee and I'm very happy with it.

If we're cruising in the Balti Sea I add 5m chain (6 mm) between ancor an rope so that I've some more security for coastal conditions. It fits into the bag also and you can remove it very quick for storage in the cabin.

I can fully recommend this spec.

Rgds

Frank

It looks like a neat solution to me. I would probably add 5 metres of 6mm chain, it will take very little space and will improve the holding power.

Only downside I can think of is that it will have a lot less "give" than 3 strand nylon rope which will absorb shock loads better. This may not be an issue in normal use.

Just remember Kielder Water is 44 metres deep.

Mmmm. 44m, eh? Perhaps I'd better look at getting a tender to carry it all in then

I'd imagine that for 'long term' or regular anchoring on a rough bottom a chain would stand up to the wear and tear quite a bit better, so yes, I agree, Frank, that a length of chain would be a good idea to take along too.
I'll order a length and see how we get on - I'll go for the 12mm I think as it will be a bit easier to handle and also takes a load of over 2 tons - it may come in handy on long, shallow slipways too.

Steve